EOS 94 6905 00, Инструкция по установке и эксплуатации

Страница: 16 / 44

16 Installation and Operating Instructions - MEGA
Mounting
EN
Air inlets and outlets must be installed in the cabin to ensure a sufficient air
flow in the cabin and to prevent the heater from overheating.
The required size of the air inlets and outlets depends on the heater out-
put; see 2.4 Technical data,

12.
Depending on the location of the heater, the air inlet must be installed
behind or below the heater.

Heater is located at the cabin wall,

16

Heater is located in the middle of the cabin or in front of a glass wall,

16
Heater is located at the cabin wall
The air inlet must meet the following criteria:

Location: Behind the heater

Height: 10 cm above the cabin floor
If there is still not enough fresh air to reach the heater, a fan must be
installed at the opening outside of the cabin.

Installing the air inlet in the cabin wall
Heater is located in the middle of the cabin or in front of a glass wall
The air inlet can be either a large opening or two small openings.
The air inlet must meet the following criteria:

Location: Below the heater

A duct directs fresh air to the opening or openings.

A fan must be mounted at the beginning of the duct outside of the
cabin.
A Cabin wall B Air inlet
B
A