Operating instructions
Operation
Date 15.03.2021 Version 1.3
©2021 enz® technik ag
Page
23
of
28
Figure 8: Switching the Enz® Camera on and off
5.2.1
Procedure
1.
Hold the Enz® Magnet on the activation field (see chapter
4.2 Overview Enz®
Camera
) for about 4 seconds and then remove it again.
CAUTION!
Bright flashing of all 12 LEDs when switching on the Enz® Camera!
Do not look into the LEDs directly.
All 12 LEDs illuminate 2x briefly.
The green status LED illuminates and the Enz® Camera is switched on.
2.
Connect the Enz® Camera with the remote client. Check the availability of the
WLAN connection "Enz Camera" in the WiFi settings of the remote client.
3.
Perform the basic settings via the remote client (Company Info, Settings etc.).
4.
Start the video recording via remote client.
5.
After finishing the video recording, stop via the remote client.
6.
Download the videos via the remote client.
7.
Hold the Enz® Magnet on the activation field (silver spot) for about 2 seconds
and then remove it again.
The green status LED goes out and the Enz® Camera is switched off.
