Envirovent ECO DMEV SELV, Инструкция

Страница: 11 / 12

ATTENTION: When the humidity rate
is above the selected value, the
automatic option takes precedence
over the manual.
Settings
The settings at manufacture are 60%HR
for humidity and 1 minute for timer.
The desired humidity level is selected by
means of a potentiometer “
P3
” positioned
on the printed circuit board (fig.8).
- To reduce the humidity setting turn
anticlockwise (min.60 %)
- To increase the humidity setting turn
clockwise (max. 90 %)
To set the timer, turn the potentiometer
“
P2
” on the printed circuit board (fig.8):
- To reduce the "run on" time, turn
anticlockwise (min. 1 minute)
- To increase the "run on" time, turn
clockwise (max: 30 minutes).
Specific recommendations:
- If you change the settings of the extract
fan you have to handle the
potentiometers in the printed circuit
board. These potentiometers are
fragile and must be handled with care.
- Do not change the setting of the
humidity sensor out of the room where
the fan will be installed.
- If the humidity is always above 90%
RH, the fan will always run at full
speed.
- If the humidity in the room is always
less than 60%, the fan will only operate
on trickle speed when running in
automatic operation.
If the fan never runs on boost:
- The setting of the humidity sensor has
been set to maximum. Change the
setting
- The level of humidity in the room is
below 60% RH
If the fan always runs at boost
- The setting of the humidity sensor has
been set to the minimum. Change the
setting
- The level of humidity in the room is
above 90% RH
ECO dMEV HTP
ECO dMEV version similar to H model,
fitted with a manual pull cord to operate
the boost when the humidity level is
below the set point (fig.6)
When switching the pull cord off, the fan
will continue to operate on boost for the
time set by the timer then will revert to
trickle speed, unless the humidity level
exceeds the set point.
Maintenance
IMPORTANT: DISCONNECT FROM
THE MAINS SUPPLY BEFORE
CARRYING OUT ANY MAINTENANCE
The extract fan only requires periodical
cleaning using a cloth lightly impregnated
with a soft detergent.
After Sales Service
We recommend you not to try to
dismantle or remove any other parts than
those mentioned as any tampering would
automatically cancel the EnviroVent
guarantee. If you detect any fault, contact
EnviroVent on 01423 810810.
If you have any problems, please call our
dedicated Technical Team on 0845 27 27
810.
All EnviroVent products are designed to
be recycled when they reach the end of
their useful life. To save the environment
and to reduce landfill, please call
EnviroVent on 01423 810810.
EnviroVent reserves the right to alter specifications
without notice