Envirologix QuickSCan II, Руководство пользователя

Страница: 15 / 25

11
With scissors, cut the reacted test strips just above the colored arrow tape.
Open the QuickScan drawer by pushing in the drawer face
–
it will pop open.
Place single strips on the right side of the tray
–
slip them into the slots
designed to hold the strips. The strips must be facing up, with the barcode
end of the strip closest to you
–
the barcoded end slides into the strip slots.
Place combs, also face-up, onto the left side of the tray. QuickScan has the
ability to read various combinations of combs and/or strips simultaneously.
Press the drawer closed. From the Main Menu, click Read Test. The reading
process will take several seconds before QuickScan advances to the Results
Screen. At that time, remove strips from the tray in preparation for the next
read.
Reading Multi-Matrix Barcode Cards
Multi-Matrix Barcode Cards enhance the
functionality of test strips by increasing the
variety of matrixes that can be tested with the
strip. Unique standard curves are applied to each
Matrix Group, and are encoded as barcodes on
the Barcode Card included in the kit box.
The curves must be uploaded into the program prior to running the test
strips. To do this, open the drawer and slide the MMBC
–
face up
–
into the
clips in the back of the drawer, close the drawer, then click “Read Test” from
the QuickScan Main screen.
Once the unit has finished scanning the
card, a dialog will appear indicating that
the barcodes have been uploaded.
Please be sure to verify that all of the barcodes have been successfully
uploaded by matching the Matrix Groups shown on the card to the Matrix
Groups shown in the dialog. Once barcodes are uploaded, they will remain
permanently in the program’s memory, and thus the card will not need to be
scanned again. Please note: the Barcode Card will need to be scanned each
time you receive a new lot of strips.
Once uploaded, the test strips can be run and scanned as described in the
“Reading Test Strips” section. Prior to advancing to the Results Table,
however, you will be prompted to select your Matrix Group. You will see an
abbreviate
d Results Table with the “Test Kit” and “Matrix Group” columns:
Select the Matrix Group
for each strip from the
drop-down menus in the
Matrix Group column. For