Enviro Q2LI, Руководство пользователя

Страница: 39 / 48

Page 39
Secondary Installation
p
aneL
i
nstaLLation
(o
ptionaL
):
These instruction are applicable to both the Q2 model brick liner set (50-2977) and the Q2 model enamel
porcelain liner set (50-2978).
DATE: 8/7/2014 BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 1
SHEET:
STOVE:
UPDATED: ----/--/-- BY --
REVISION:
0.0
Step 1
:
Be sure the fireplace is cool.
Remove the door, the log set (if installed),
log grate, burner tube, and the upper
and lower air diverters. Removal of these
parts will be found in the m
aIntenance
anD
s
erVIce
section of this manual. Once
all required components are removed your
appliance should resemble Figure 42.
Step 2 : The panels are
delicate so please handle
with care. Remove the panels
from their packaging and insert
the rear liner first followed by
the sides. Hold into position as
shown in Figure 43.
Step 3
:
Screw the (2) retainer brackets into
the existing exhaust baffle with the supplied
#8 T-20 bolts. Before tightening press the
retainer onto the panel firmly. Tighten them
once the panels seems to be in the correct
position. (See Figure 44)
Figure 42. Firebox liner preperation
Figure 43. Liner panel retainers
Figure 44. Liner panel position
Be sure to remove
the upper steel air
deflector. The panel will
sit behind it.
Re-install the upper
steel air deflector once
your panels are set.