Installation
i
nSide
v
ertical
i
nStallation
:
1. Choose a stove location that is ideal. See the section Deciding Where to Locate Your Pellet
Appliance.
2. Place a non-combustible hearth
pad where necessary.
3. Place the unit on the hearth
pad and space it in a manner so
when the pellet vent is installed
vertically, it will be 3” (76 mm)
away from a combustible wall.
4. Locate the center of the fresh air
intake pipe on the unit. Match
that center with the same point
on the wall and cut a hole about
1
5
/
8
” (41 mm) in diameter.
5. Install the fresh-air intake pipe.
6. Install the tee with clean out.
7. Install the pellet vent upward
from there. When you reach
the ceiling make sure that the
vent goes through the ceiling
firestop. Maintain a 3” (76 mm)
distance to combustibles and
keep attic insulation away from
the pipe.
8. Finally, extend the pellet vent to
go through the roof flashing.
9. Ensure that the rain cap is
approximately 36” (914 mm)
above the roof.
Figure 20
16
