Enviro DRIFTWOOD E33, Руководство пользователя

Страница: 10 / 40

Maintenance And Service
Warning:
Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance, may result in property damage or personal injury.
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified person.
c
Leaning
t
he
g
Lass
:
When the fireplace is cool
, remove the glass door. See m
aIntenance anD
s
erVIce
- g
lass
D
oor
r
emoVal
.
Check the gasket material on the back of the glass, making sure that it is attached and intact.
During a cold start up, condensation will form on the glass. This is a normal condition with all fireplaces.
However, this condensation can allow dust and lint to cling to the glass surface. Initial paint curing of the
appliance can leave a slight film on the glass. The glass will need cleaning after the fireplace has cooled
off from the first burn and about two weeks after first burn. Use a mild glass cleaner and a soft
cloth . Abrasive cleaners will damage the glass and painted surfaces. Depending on the amount
of use, the glass should require cleaning no more than two or three times a season. Do not clean the
glass when it is hot.
c
Leaning
t
he
f
iRebox
:
Remove the logs carefully, as they are very fragile. Gently remove all the embers and rock wool and
place on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off the
logs and remove any lint from the burner and pilot. At this time, inspect the burner tube for cracking or
severe warping. If a problem is suspected, contact the dealer. Check the logs for deterioration or large
amounts of soot; a small amount on the logs is normal. Replace the logs and embers as in the s
econDary
I
nstallatIon
- l
og
s
et anD
e
mber
I
nstallatIon
section. If new/more embers and rock wool are required,
contact your nearest ENVIRO dealer.
R
ePLacing
t
he
g
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see p
arts
l
Ist
). Wear gloves when handling damaged glass door assembly
to prevent personal injury. Do not operate with the glass front removed, cracked or broken. Removal
and replacement of the glass from the door must be done by a licensed or qualified service person.
The glass must be purchased from an ENVIRO dealer. No substitute materials are allowed.
Remove the door (see page 11). The replacement glass will come with a new gasket installed. Remove
any silicone remnants from the door. Apply high temperature silicone to the two vertical faces of the
door and install the new piece of glass with gasket (be sure to maintain edge clearances). Apply even
pressure to the glass to allow the silicone to adhere to the gasket material.
10
c
heck
P
iLot anD
b
uRneR
f
Lames
:
Periodically do a visual check of the pilot flames. One flame should encompass
the ignitor and thermocouple and the other should burn over the burner ports
(see Figure 7). Also check that the burner is operating correctly, refer to Venturi
Adjustment section.
Figure 7: Pilot Flame