Enviro C-11288, Руководство пользователя

Страница: 20 / 34

Secondary Installation
L
OG
S
ET AND
E
MBER
I
NSTALLATION
:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched”
and will not burn correctly. The burner comes with placement pins and rest areas, which make alignment
easier. Using Figures 27 to 31, carefully set the logs in place.
NOTE: The logs are fragile and should
be handled with care.
Place the rear log on the two back placement
pins.
Install the left front log on the left placement
pin with the narrow end of the log resting on
the rectangular rest area.
Install the right front log on the right
placement pin with the narrow end
of the log resting on the rectangular
rest area. The last two logs should
meet tip to tip on the rest area.
One end of the big log twig will rest
on the pin on the right log and the
other will lay within the left rest
area.
The small log twig should be placed
so it sit completely within the right
rest area.
Once the logs are in place the embers
can be placed lightly between the
logs. Bags of ceramic fiber embers
and rock wool are provided. The
ceramic fiber comes in chunks that
are about 2”-4” (5-10cm) long.
Break these roughly in half and
place them irregularly around the
burner. When there is a sparse but
even layer of embers, spread the
rock wool in the same manner. DO
NOT pack this ember material as this
could create an unsafe condition.
The pieces should be lightly place so
they don’t completely block any of
the tiny ports. DO NOT allow any of
the embers to rest against the pilot
assembly.
Figure 27: Focus burner.
Figure 28: Focus Log Placement 1.
Figure 29: Focus Log Placement 2.
Figure 30: Focus Log Placement 3.
20