Chapter 4. Door Station Installation
IP Video Door Station Installation User Manual
20
Step 14
: using the crimped cable connect the RJ45 socket (ETHERNET) of the door station
controller (
Pic 3.3, 3.4
) straight to a PoE supported router or by means of a PoE injector if the
router does not support PoE (see schemes 2, 3).
If PoE is not used, then connect the RJ45 socket (ETHERNET) of the NC101 controller to a
router using the crimped cable and connect the «G» and «12V» pins of the controller with an
external DC 12V power source.
To prevent the door station malfunction use only equipment recommended by Enviro Cams.
4.4. Memory Card Installation
Do as follows to install a memory card.
Step 1
: remove the 4 screws and open the split-type door station housing. The memory
card slot is situated on the upper interface board, on its back side.
Step 2
: take the memory card in a way that its contacts are directed to the interface board
and to the slot and insert it in the slot; you should feel/hear a little click.
To eject the memory card from the slot press it to feel/hear a click and then it will be pushed
out by a spring.
NOTE!
Switch off the door station before installation/ejection of the memory card. The hot swap of a memory card
is not supported by the door station and may damage the equipment or cause a data loss.
Step 3
: close the split-type door station housing and fix the 4 screws.
