Pixel Triton User Manual
Part No.: 51322
For latest version visit:
www.enttec.com
25 October 2018
mfile ID: 4815381
Page|
8
Universe/Output
The
Pixel Triton allows conversion of up to four
universes of DMX over Ethernet to pixel data per
output.
Both outputs could be specified to use the same
universes, e.g. both outputs use universe 1,2,3 and
4
Each output can also be specified to use its own
individual group of universes, e.g. output 1 uses
universes 100,101,102 and 103 however output 2
uses 1,2,3 and 4 as shown in the image
Only the first universe can be specified; the
remaining universes, second, third and fourth are
automatically assigned subsequent universes to
the first one
Example 1:
If the first universe is assigned 25, the second, third
and fourth universes will be automatically
assigned 26, 27 and 28 as shown in the image below.
Example 2:
When output 2 is driving 3 universes and first
universe is specified to be 5, second and third
universes are automatically assigned 6 and 7 as
shown in image below.
Mapped Pixels
This setting together with the Universe/Output and
Group Pixel eventually determine the number of
pixels that can be
switched on at the output
Group Pixels
Controls the number of pixels controlled by each
DMX channel
Example:
For the above image, when group pixel is set to 10,
each DMX channel of universe 0 will control 10
pixels
Maximum Pixels
This parameter is display only and shows the
maximum pixels driven by an output
