Amulet High Definition Television Receiver User’s Guide
Copyright
2007 Entone, Inc. All rights reserved
.
17
SETTING HDMI AND COMPONENT OUTPUT RESOLUTION
You can select 1080i, 720p, 480p or 480i on the HDMI and Component output. When you set the output,
both HDMI and Component outputs are set to the selected resolution. The S-Video, RCA Composite and
RF outputs are always set to 480i and will not be affected by the HDMI and Component resolution setting.
To select the HDMI and Component output resolution:
1. Press and hold the Amulet front panel “UP” arrow for 5 seconds.
2. Keep on pressing the “UP” arrow, the resolution indicator in the Amulet front panel display will illuminate
in a round robin manner from “1080i -> 720p -> 480p -> 480i”.
3. When your desired resolution is illuminated, release the “UP” arrow. Then, both the HDMI and
Component outputs will be set to the selected resolution.
Figure 4-6 Setting HDMI and Component Output Resolution
NOTE:
If your TV does not display the video or error message is displayed after you have selected a new
resolution, your TV may not support the selected resolution. Refer to your TV owner’s manual for
verification. Repeat the above procedures again to find a resolution supported by your TV.
