5
ASSEMBLY PROCEDURES
Step 1: Support Arm Assembly
① ATTENTION! All M10x40
Button Head Screws (15), require
a drop of thread glue (23), and
installation/tightening within 2
minutes of glue application.
② Connect Upper Connecting
Plate (5), on Support Bar (2), and
secure with M10x40 Button
Head Screws (15), as shown.
Note: Use Thread Glue (23), on
screws as noted in ①.
③ Connect Driver Side Front
Leg Rail (3), & Lower Connecting
Plate (6), to bottom of support
bar (2), using M10x40 Button
Head Screws (15), as shown.
Note: Use Thread Glue (23), on
screws as noted in ①.
④ Secure Upper (5), and Lower
(6), Connecting Plates using
M10x55 Button Head Screws
(17) and
M10 Lock Nuts (18), as
shown.
⑤ The front driver side support
arm is now assembled. Confirm it
is correct using the diagrams
below.
⑥ Repeat this support arm
assembly procedure using the
Passenger Side Front Leg Rail
Mount (4). Then complete the
rear support arms in the same
manner.
CORRECT assembly example
for front and rear driver side
support arms.
The upper connecting base (5),
is level and parallel to rear leg
rail mount (3).
INCORRECT
assembly
example for front and
rear driver side support
arms.
The upper connecting base (5),
is not level and parallel to rear
leg rail mount (3), because it is
facing the wrong direction.
