Enterasys VHSIM-G6, Руководство пользователя, Страница: 24 / 44

Chapter 2: Installation
2-2 VHSIM-G6 User’s Guide
2.2 INSTALLING THE VHSIM-G6
You can install a VHSIM-G6 in any Cabletron Systems device that
supports VHSIM technology (e.g., 2E253-49R, 6H252-17).
The following subsections provide instructions for installing a
VHSIM-G6 in an interface module or in a standalone device. Refer to
your specific interface module or standalone device documentation for
exact VHSIM slot and connector locations.
2.2.1 Installing the VHSIM-G6 in an Interface Module
To install a VHSIM-G6 in an interface module that supports VHSIM
technology, perform the following steps:
1. Note the ports of the interface module that have cables attached to
them. Write down the ports and label the cables to make it easier to
reattach the network properly after the installation. Then disconnect
the cables from the ports.
2. Attach the antistatic wrist strap (refer to the instructions outlined in the
interface module User’s Guide).
3. If the module is installed in a chassis, unlock the top and bottom plastic
locking tabs of the module faceplate, and remove the module from the
chassis.
NOTE
Refer to the release notes for the version of firmware running
on the Cabletron Systems device to ensure that the VHSIM-G6
is supported.
!
CAUTION
The VHSIM-G6 and the host module are sensitive to static
discharges. Use an antistatic wrist strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the VHSIM-G6 or host module.