Enterasys Matrix 7H4385-49, Руководство по установке оборудования

Страница: 61 / 92

Using LANVIEW
DFE-Platinum Series Hardware Installation Guide 4-3
3. Press the GROUP SELECT button again for more than one second. This returns the
7H4385 ‐ 49 to the default status mode to monitor RX (receive) and TX (transmit)
activity.
Table 4 ‐ 1 describes the LED indications and provides recommended actions as
appropriate.
Note: The terms used in Table 4-1 indicate the following:
• Flashing indicates LED is flashing randomly.
• Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).
• Solid indicates a steady LED light. No pulsing.
• Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.
Table 4-1 LANVIEW LEDs
LED Color State Recommended Action
MGMT Off Off . This DFE module is NOT
the Management Module.
None.
Green Solid . This module is the
designated Management
Module.
None.
Amber Flashing . This is a
temporary indication that the
DFE module is saving data.
None.
CPU Off Power off. Ensure chassis has adequate power.
Amber Blinking . DFE module in
process of booting.
None.
Solid . Testing. If the LED remains amber for several
minutes, contact Enterasys Networks
for technical support.
Green Blinking . Image starts
running.
None.
Solid . Functional. None.
Red Solid . Processor in reset. None.
Green and
Amber Blinking . Indicates that the
DFE module is in the process
of shutting down.
None. This state is activated when the
OFFLINE/RESET switch is pressed for
less than 1 second to start the process
of an orderly shutdown.
While in this state, do not remove any
DFE module.