Enterasys Matrix 7H4382-25, Руководство по установке оборудования, Страница: 73 / 78

Memory Locations and Replacement Procedures
DFE-Platinum Series Hardware Installation Guide B-7
DIMM Replacement Procedure
In the event that the DIMM needs to be replaced, the following sections explain how to
remove and install the DIMM. If you have questions concerning the replacement of the
DIMM, refer to “Getting Help” on page xviii for details on how to contact
Enterasys Networks.
Removing the DIMM
To remove the existing DIMM, proceed as follows:
1. Locate the DIMM connector on the main PC board. Refer back to Figure B ‐ 2 for the
DIMM location on the 7H4382 ‐ 25.
2. Push the connector arms away from the DIMM, as shown in Figure B ‐ 6 , and
simultaneously lift the DIMM enough to release it from the connector fingers.
Figure B-5 Installing the DRAM SIMM on 7H4382-25
1 Connector arms 3 Connector fingers
2 DRAM SIMM memory module 4 Alignment notches (2)
Â
À
À
Á
Ã
Ã
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.