background image

Quick Start User Guide

v.1.2   

2.8.1 Browse to pocentel.co.uk and log in.

2.8.2 Select the server 

the Gateway is 
being used on 
and click ‘Manage 
radios’. 

 

You should see 
the Gateway 
serial number at 
the top of the list.

2.8.3 You can now 

configure the 

Gateway’s E-PoC 
Group etc. as well 
as the Gateway 
radio’s RF 
channel, group 
etc.

2.8.4 You must use the Gateway’s web page for the following settings.

2.8.5 POC Setup

 

This allows changing of the e-PoC credentials 

configured for the gateway by the provisioning server. 

 

It should be used with care as entering the wrong 
information can mean the gateway will not connect. 

 

To revert to the provisioned settings, tap on Set 
Default.

2.8.6 Changing the gateway audio output level (PMR 

Network side)

 

This allows changing of the output volume from the 
gateway (towards the DMR network). 

 

To change move the slider left to decrease volume or 
right to increase volume. 

 

Changes are applied as soon as the slider is moved.

2.8.7 Non-Entel and P1 servers

 

If you are using a P1 or a non-Entel PoC server, for example, Tassta, it will be necessary to 
change the APK version to match your server version. see section 2.8.8

2.8.8 APK Store

 

To download and install a new APK, first connect to the 

gateway via its connected network (see section 2.6). 
Then select ‘APK STORE’

 

Select the required APK from the 
APK pulldown and click ‘APPLY’

 

 

The APK will be downloaded 
and installed. Please allow a 
few minutes for this process to 
be completed. The Gateway will 
display the download process.

 

After installation, the Gateway will re-boot and connect to your server using the new APK.

2.9   About

 

This shows information about the gateway and its current 
connection. 

 

The information is refreshed every few seconds.

2.10  Change the Gateway Password

 

Enter the new password and enter the same one in the 

confirmation field and then apply. 

 

You will need to login again with the new password to 
continue.

2.11  Factory Reset

 

Factory reset will revert all settings to the factory defaults. 

 

The gateway will restart and it will take several minutes to 
complete this operation. 

 

WARNING: All PoC, WiFi and network settings 

configured on the gateway will be lost. Settings 

configured via pocentel will be retained.

 

Tap OK to proceed or Cancel to revert to previous screen.

2.8 PROGRAMMING THE GATEWAY

Supplied accessories:

CWCxx

Mains to 12v power supply

CATxx

Radio antenna (should be cut to Centre frequency)

CATWIFI

WIFI antenna

NOTE: The LAN cable connected to our device should be no longer than 10 metres.

Отзывы: