TM
BrightEye 90-A
BrightEye 90-A - Page 11
HD/SD SDI/Cpst In
This BNC input accepts an analog composite video signal, an HD SDI serial
digital video signal, or an SD SDI serial digital video signal with or without
embedded audio. External AES audio can be inserted into the SDI input stream
or replace existing embedded audio.
Ref In
This BNC accepts an analog composite video signal or Tri Level Sync signal
which is used as the genlock and timing reference for the internal Frame
Synchronizer. Typically the reference signal is Color Black or Color Bars fed from
a master sync generator (such as the BrightEye 55).
Analog Audio Connectors
The four Phoenix connectors are either analog audio inputs or outputs depending
on how the unit is configured (Mux 8, Mux 4, or Demux). Each connector inputs
or outputs 2 channels of audio (1 pair.) When the unit is configured as Mux 8, the
four Phoenix connectors are inputs. When configured as Demux, the four Phoenix
connectors are outputs.When configured as Mux 4, two Phoenix connectors are
inputs and two Phoenix connectors are outputs.
Each Phoenix connector is fitted with a pluggable terminal block that accepts
bare wire leads. Wires can be inserted into the small round holes. Depress the
orange tab to release them.
OPERATION
Control and operation of the BrightEye 90-A is performed from the front panel or
remotely from a networked PC with the BrightEye PC or BrightEye Mac Control
application.
Some control settings are only available with BrightEye PC or Mac. These parameters
cannot be monitored or controlled from the front panel.
Front Panel Controls and Indicators
The front panel of the BrightEye 90-A, shown above, provides status indicators
and control for the unit.
BrightEye 90-A Front Panel
NOTE
:
