ENQUATICS AquaMaster Masters Decorative Series, Руководство пользователя

Страница: 5 / 37

MASTERS DECORATIVE ASSEMBLY INSTRUCTIONS
WARNING: Read these instructions carefully. Failure to follow these
instructions could cause a malfunction of the system. Improper installation,
wiring or anchoring could result in property damage or bodily injury.
Carefully unpack your unit and inspect for damage.
Parts Included:
1 – Float
1 – Intake Screen with Fasteners
(Nut, Washer and Bolt Included)
1 – Power Unit and Power Cord
6 – ¼-20 Socket Head Cap Screws
1 – 3/16” Allen Wrench
1 – Owners/Instruction Manual
FLOAT ASSEMBLY
1. Slide the float onto the float tube until it bottoms against the impeller housing.
The float must be installed as shown with the inner ring toward the motor.
Installing the float upside-down will adversely affect its performance.
2. Using the 3/16” Allen wrench, install four (4) of the ¼-20 socket head cap
screws into the upper float tube mounting holes. These holes are closest to the
grooved end of the float tube. DO NOT over-tighten the screws.
3. Slide the float up until the socket head cap screws are seated in the slots on the
top of the float.
4. Maintain this float position and install the two (2) remaining ¼-20 socket head
cap screws in the float tube found on the bottom of the float. DO NOT
over-tighten the screws.
Pictures and images used in this manual are for representational
purposes only, may not depict the actual product.
Page 2