7
en
Fill the Reservoir
Remove the fill cap to fill the reservoir with 14 oz of clean, cold
potable water. While holding the unit in the horizontal position, fill
reservoir about half full. Securely replace the fill plug. Turn bottle
in vertical position and check fill line. Repeat until water reaches
fill line. Do not overfill. Do not fill with hot water.
Prime the Spray Bottle
When new, or after long storage, the ozone generator in the head
of the bottle may become deprimed and dry. When dry, the ozone
cell will shut down after 2 seconds and the red and blue lights
will flash twice. To prime the ozone cell, repeat spraying until the
error condition clears. After 10-20 sprays, pause 60 seconds
and continue. Once fully wet, the ozone generator will operate
without shut down.
Sanitize Hard Non-Porous Surface
Hold the spray bottle 6 to 8 inches from the surface and spray
evenly until wet. For 99.9% effectiveness against common
pathogens allow to stand for 30 seconds. Wipe with a clean
cotton or microfiber cloth or allow to air dry. No rinsing is
necessary (leaves no residue).
Ozone is generated on demand. While spraying, the blue indicator
will light when the unit is operating properly.
Remove cap.
Fill approximately half full in
horizontal position.
Secure fill plug.
Sit bottle on counter and check
water level with fill line.
Hold 6-8” away from surface.
While spraying, blue light indi-
cates unit is working properly.
CAUTION
FILL WITH CLEAN, COLD POTABLE WATER ONLY.
DO NOT OVERFILL THE BOTTLE.
DO NOT RUN WATER INTO THE CHARGER PORT.
WATER TEMPERATURE 40 °F to 86 °F (4 °C to
30 °C)
