OPERATING INSTRUCTIONS
ASSEMBLY STEPS
Before using your unit, make sure you inspect the following things:
1. Cord is not broken
2. Adhesive gel is not damaged
3. Electrode cord connection is not broken
4. Unit is intact and working
5. There is no battery leakage.
STEP 1 – CONNECT ELECTRODE WIRE TO MAIN UNIT
(WARNING: MAKE SURE THE UNIT IS TURNED OFF)
• Connect the electrode wire plug to Channel A or Channel B on the
bottom of your unit.
STEP 2 – SNAP ELECTRODE WIRE TO MASSAGE PADS
• Connect the two ends of the electrode wire to the massage pads by
snapping the round plugs on the pins attached to the cloth side of
the massage pads.
• NOTE: Please make sure to clean your skin thoroughly to remove any
oils, dirt, or impurities as these may cause the adhesive gel to fail
during therapy. Pads may not stick if the skin has too much hair.
We recommend shaving the area for effective results.
STEP 3 – REMOVE PROTECTIVE PLASTIC FILM FROM PADS
• Remove the clear plastic film from the back of the pad.
• Discard the plastic film and bag.
STEP 1
STEP 2
STEP 3
A
B
