Enovate Medical e997, Руководство пользователя

Страница: 11 / 32

11
20 GAGE (.035") OR HEAVIER METAL STUD
(Preferred method of mounting)
STEP 1
For easier installation, install the Wall Track End Cap to the wall track using two 10-24 x 1/2" Button
Head Screws before mounting the track to the wall.
STEP 2
Determine the desired keyboard height. Use the chart on page 10 for standard keyboard heights; adjust
vertical dimensions as required for desired keyboard height.
STEP 3
Locate the exact center line of the wall stud where the track will be mounted.
STEP 4
Using a level, mark the hole locations for the appropriate track size using the dimensions to the left
(make note of the bottom of the track).
STEP 5
Place the track against the wall and secure with the Wide Flat Washer, the Phenolic Washer and the Hex
Head Self Tapping Metal Screw.
DO NOT DRILL PILOT HOLES.
STEP 6
Ensure track is level before fully tightening screws.
DO NOT OVER TIGHTEN SCREWS.
For stripped holes in metal studs, see page 13.
Description Part Number

1/4-14 x 2 1/2"
Hex Head Self Tapping Metal Screw
HX-WHDS .25-14 x 2.5 ZNC

Wide Flat Washer SWFW 1/4 x 1.00 TYPE A ZNC

Phenolic Washer PH-WSH .25 x 1.0
Note: When mounting in California, please refer to OSHPD code OPA 26710.

 