USER MANUAL
PTM 215B – BLUETOOTH
®
PUSHBUTTON TRANSMITTER MODULE
© 2019 EnOcean | www.enocean.com
F-710-017, V1.0
PTM 215B User Manual | v1.9 | June 2019 | Page 16/85
Source address
The 6 byte BLE Source Address (MAC address) uniquely identifies each PTM 215B product.
PTM 215B supports two source address modes:
Static Source Address mode (default)
In this mode, the source address is constant (but its lower 32 bit can be configured
via NFC interface)
Resolvable Private Address mode (NFC configurable option)
In this mode, the source address changes for each transmission
By default PTM 215B uses Static Source Address mode. Private Resolvable Address mode
can be selected by setting the
Private Source Address
flag in the
Configuration
register
(see chapter 6.7.3) to
0b1
.
These two address modes are described in the following chapters.
4.4.1
Static source address mode
By default, PTM 215B uses static source addresses meaning that the source address is con-
stant during normal operation. The static source address can be read and configured (writ-
ten) via NFC as described in chapter 6.
The structure of PTM 215B static addresses is as follows:
The upper 2 bytes of the source address are used to identify the device type and set
to
0xE215
for all PTM 215B devices (to designate EnOcean PTM 215 device type).
These two bytes cannot be changed.
The lower 4 bytes are uniquely assigned to each device. They can be changed using
the NFC configuration interface as described in chapter 0
Figure 11 below illustrates the static address structure used by PTM 215B.
Figure 11 – BLE static source address structure