3.5 FCC/IC Approval Requirements
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. If
this device is operated in compliance with the following requirements
it can be operated
without notification and free of charge in the area of the United States of America
and in Canada
. Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that
may cause undesired operation.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions. (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC ID:
SZV-PTM200C
IC:
5713A-PTM200C
Trade Name: PTM200C
Model No: PTM200C
Warning:
Changes or modifications made to this equipment not expressly approved
by EnOcean may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Due to FCC 15.231 operational and timing requirements the PTM 200C switch device
must
not be operated more than 1088 times per hour
(pushed or released as one operation
each):
•
Total duration of transmissions must not exceed more than two seconds per hour
•
PTM 200 packet length is 0.7 ms, max. 5 redundant packets, tolerance of 5% in packet
length, 50% on average packet Ton/Toff ratio
This Class B digital apparatus complies with Canadian ICES-003.
©EnOcean GmbH, W. Heller
Page 17 of 19
PTM 200C User Manual V1.01
