VIII – GAS ADJUSTMENT
JETS AND OUTPUT
Burner
Nominal
output
NGC
Propane 2,75kPa
Watt
Mj/h
Jet size
Input g/h
Large
2500
8.5
80
182
Medium
1750
5.9
67
127
Small
1000
3.0
50
73
"Enamelled" oven
1700
5.7
69
131
"S.Steel" oven
1500
4.8
60
109
Grill
1350
4.4
58
98
Air ring adjustment on oven burner
How to remove the "U"-shaped burner:
-
Unscrew the fixing screw placed in front of the thermocouple.
-
Remove thermocouple fixing screw
-
Remove oven burner and adjust according to drawing.
IX – UTILISATION
VENTILATION
Operating a gas cooking appliance brings about heat and damp exhaust in the room where it is being operated. Always
make sure that the room is properly ventilated: keep natural aeration apertures opened or install a mechanical aeration
device (hood). Intensive and prolonged operation can require extra aeration (by opening a window) or by providing a
more efficient aeration (hood - if any - on full on position).
HOW TO CHOOSE COOKING USTENSILS
The pan diameter should be suitable for the burner output to avoid any useless energy consumption.
-
Use Ø 120 mm diameter pans with the small burner (1000 W)
-
Ø 120 to 200 mm diameter pans with the small burner (1750 W)
-
Ø 180 to 260 mm diameter pans with the large burner (2500 W).
X – MAINTENANCE INSTRUCTIONS
Do not use any abrasive cleaner. In the event of overflowing, use a wooden spatula.
Clean up spillage of acidic liquids immediately i.e. lemon juice, vinegar, etc...
On the very first operation, the stainless steel upper grid and oven bottom plate can
yellow a little bit.
For an easy cleaning of the upper part, lift the grid (see drawing). To clean it,
unlock the pan-holders by unscrewing the fixing screws and push the holders to the
right or to the left.
Grid, burner caps and cups can be removed and cleaned with appropriate cleaners
knowing that cups are made of aluminium. Dry carefully before reassembling and
make sure every part is correctly reset. While operating, the flame is considered as
correct when the tongue is blue. If the tongue is yellow, it is essential to check that
every single burner part is properly reset. Anomalies can arise from bad
positioning.
Note: The Inside glass of the oven can be removed for cleaning by removing
the small screws holding the two brackets on and care fully sliding the glass
down until it clears the top bracket: reverse these steps to reassemble.
ABNORMAL OPERATION
While operating, the flame should be mostly blue.
Check that burner parts are correctly repositioned after cleaning and if abnormal operation
persists have the appliance serviced by a qualified person.
ANY OF THE FOLLOWING ARE CONSIDERED TO BE ABNORMAL OPERATION:
Yellow tipping of the burner flame.
Sooting up of cooking pots, pans etc.
Burners not igniting properly.
Burners failing to remain alight.
Burners extinguished by drafts.
Gas valves that are difficult to turn.
FOR WARRANTY SERVICE AND PARTS CONTACT:
Ocean Solutions International
Telephone: (07) 3807 6033
Fax: (07) 3807 6055
Email: service
@
oceansolutions.com.au
Unit 11 / 65 Business Street
YATALA,
Q
LD 4207
Oven burner ring
Air-adjustment
Adjust to 5 mm for
Propane 2.75 kPar
Diagram:
cleaning
