Eno Scientific Well Watch 670, Руководство пользователя

Страница: 15 / 36

show measurement data, and the SET modes are used to change operating
parameters of the Well Watch.
There are two DISPLAY modes:
1 – DEFAULT display screen which shows current measurement data
2 – TIME AND DATA display screen which shows the system time and date.
Pressing the DISP button advances the DISPLAY mode by one with each press and
starts over when reaching the end.
There are several primary user SET modes which advance with each press of the SET
button. A complete description of the SET modes can be found in the SET MODE
section of this manual. While in any SET mode, pressing the DISP button will return to
the default DISPLAY mode. Similarly when in a DISPLAY mode, pressing the SET
button puts the Well Watch in the first SET mode.
DEFAULT DISPLAY: While the display shows depth on the top line, press the UP or
DOWN button to scroll through additional information on the second line. The following
information may be available depending on options installed and enabled:
1. Probe – temperature measured in the control unit.
2. Bat – measured voltage of the external power supply.
3. Diagnostic Data – information about the quality of the measurement.
TIME AND DATE: Press the DISP button to view the system date and time. While the
date and time are displayed, press the SET button to edit the date and time. Use the
arrow buttons to adjust the information. Press the SET button again to advance to the
next number to be set. Press the DISP button to return to the depth reading.
SET MODES: Press the SET button while the depth is displayed to view and change
any of the system settings. Continue to press SET to scroll through all of the settings.
Sounding stops while in a SET mode. After 30 seconds of inactivity sounding will
automatically resume or press the DISP button at any time to return to the depth
reading instantly. While viewing a SET screen, press the UP or DOWN button to
change the value. Rapid scrolling is activated by holding the up or down button for
about a second. Scrolling gets faster and faster while the button is held down. When
the value is as desired, press the SET button to go to the next setting or the DISP
button to return to operation. The new settings are saved automatically as they are
changed so there is no need to press ENTER.
Eno Scientific Well Watch 670 Page 15