Relative Altitude Measurement:
The ennoLogic anemometer is able to display relative altitude (also
referred to as climb or ascent/descent). Relative altitude allows you
to measure changes in altitude from the point where you enter
“Relative Altitude” mode. To enter this mode, press the
Mode
button
until you get to altitude, then
press and hold the
Units
button for
five seconds
. The LCD will first display
REL
and then set
the altitude to zero. From then on, the altitude reading will display
the difference between your newly set zero reference altitude and
your current position. To change back to Pressure Altitude,
press and
hold the Units button again for five seconds
.
Calibrating Your Anemometer:
NOTE: DO NOT ATTEMPT TO CALIBRATE WIND SPEED UNLESS YOU
HAVE ACCESS TO A CALIBRATION SOURCE FOR AIR FLOW!
Your anemometer was calibrated at the factory. But you can
recalibrate it if you want by following these steps:
Step 1: To enter calibration mode,
hold the Mode button down
while turning on the anemometer
.
Step 2: Use the table below to find the parameter to calibrate. Use
the
Max
and
Units buttons
to select the number for the parameter
you wish to calibrate. Press the
Power button
to begin calibration.
Содержание eA990R
Страница 1: ...eA990R Digital Anemometer User Manual...