EN
36
Clamping the workpiece
◊
Place the workpiece under the respective
tensioning clamp (17).
◊
Press the workpiece against the fence.
◊
First undo the setting screw for the
tensioning clamp (17a) and adjust it to fit
the workpiece. Then retighten the setting
screw for the tensioning clamp (17a).
◊
Afterwards, tighten the threaded rod (27)
by turning it clockwise.
◊
To release the workpiece, turn the threaded
rod (27) anticlockwise.
NOTE
∂
Long and heavy workpieces must be
underlaid or supported at the free end to
ensure stability.
Fitting the dust collection bag
NOTE
∂
There is a risk of fire when working with
electrical appliances that have a dust
collection bag or can be connected to
the vacuum cleaner via a dust extraction
device! Under unfavourable conditions,
wood dust in the dust collection bag may
ignite spontaneously. This can happen, for
example, due to flying sparks when grinding
metal or metal residues in wood. There is
an increased risk if the wood dust is mixed
with other chemical substances and heat is
generated by prolonged sanding. Therefore,
do not allow the workpiece to overheat and
always empty the dust collection bag or
the dust bag of the vacuum cleaner before
taking a break from work.
∂
Check that the dust collection bag is fitted
correctly.
∂
Observe the applicable regulations in your
country regarding the materials to be
worked.
◊
Press together the two fastening clips (24a)
on the opening of the dust collection bag
(24) to widen the opening.
◊
Push the dust collection bag (24) onto
the dust extraction connection (23) and
release the fastening clips (24a). Make sure
that the zip on the dust collection bag (24)
is facing downwards.
5. Operation
WARNING!
∂
Wear your personal protective equipment
when working with the Mitre Saw.
∂
Always switch the appliance off and
remove the battery before carrying out
any work on the appliance.
Setting the table
◊
Undo the locking screw for the table (6).
◊
Turn the saw at the carrying handle (22) to
the desired position. You can determine the
set angle using the mitre scale (11) and the
display arrow (10) on the table.
◊
Retighten the locking screw for the table
(6).
Making cuts without a mitre angle
◊
If necessary, adjust the table (9) as
described in the section "Setting the table".
◊
Use the supplied hex key (37) to turn the
locking nut (13) to set the adjustable
fence (12). Slide the adjustable fence (12)
inwards as far as possible. Retighten the
locking nut (13).
◊
Place the workpiece to be machined up
against the adjustable fence (12). Fasten it
as described in the section "Clamping the
workpiece".
◊
Push the safety lock-off (15) and Press the
On/Off switch (1) and keep it pressed in.
The saw starts up. Then press the handle
(2) down carefully lower the saw onto the
workpiece. Saw by applying moderate
pressure.
◊
After completing the cut, release the On/
Off switch (1). Allow the saw to stop turning
before moving it back to the starting
position.
Carrying out mitre/bevel cuts
◊
If necessary for mitre cut, adjust the table
(9) as described in the section "Setting the
table", carry out the cut.
◊
Set the desired saw bevel inclination from
Содержание 166892.01
Страница 77: ...cod articolo 166892 01 ...
