EN
31
the saw blade is the same as the one shown
on the upper fixed guard (3).
8. Secure the saw blade (6) with outer flange
(6b) and clamping screw (6a). Tighten
the clamping screw (6a) in anti-clockwise
direction with the hex key.
9. Turn the saw blade by hand to test if it is
rotating smoothly. It should not flutter.
10. Secure the guard mounting plate (4) and
lower guard in reverse order as described
above.
11. Switch the mitre saw on and let it run idle
for about one minute, to confirm that the
saw blade has been installed properly. If you
find any abnormal vibration or excessive
noise switch off and re-fit the saw blade
according to the above instructions.
Power Cord.
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared
supply cord available through the service
organization.
7. Storage and transport
∆
Switch off and unplug the appliance before
storage.
∆
Allow the mitre saw to cool down.
∆
Clean the mitre saw as described above
before storage.
∆
Store the mitre saw in a dry and secure
place well out of reach of children.
∆
Dry and protected from frost and heat.
∆
We recommended using the original
package for storage to protect it against
the dust.
∆
Transport the mitre saw in the locked
position.
∆
Grasp the operating handle when lifting it
and put into the original package before
transport.
∆
Protect the mitre saw from any heavy
impact or strong vibrations which may
occur during transportation in vehicles.
∆
Secure the mitre saw to prevent from
slipping or falling over.
8. Spare Parts/Accessories
Only use the accessories and additional
equipment that are specified in the operating
instructions.
And this mitre saw does not contain any parts
that can be repaired by the consumer. Contact
the Service Center to have it checked and
repaired.
