ENKHO 149799.01, Оригинальное руководство пользователя

Страница: 35 / 73

35
EN
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp
hands.
• Set the switch for clockwise/counter-
clockwise rotation (3) to centre position
(lock).
• Hold onto the mains plug while pulling the
power cable of the charger out of the mains
socket.
• If required, allow the device to cool down.
• Remove the battery from the device (see
Start-up chapter).
• Remove the tool from the device (see
Start-up chapter).
• Clean the device according to the
Maintenance chapter.
• Store the device according to the Storage
chapter.
7. Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than
those specified in the operating manual may
cause a risk of injury.
Designation
SDS drill bit and chisel set, 11-piece
Screw bit set, 32-piece
Spare battery 2.0 Ah 20V
8. Errors and faults
The device has been checked for proper
functioning several times during production.
If malfunctions occur nonetheless, check the
device according to the following list.
Troubleshooting tasks which require the
housing to be opened must only be carried out
by an authorized specialist electrical company
or by Eurospin.
Slight smoke or odour are emitted during first
use:
• This is not a fault. These phenomena
disappear after a brief runtime.
The battery does not charge:
• Check whether the battery is correctly
connected to the quick charger.
Slide the battery into the quick charger in
a way that the battery terminals engage in
the quick charger. The battery must lock in
place in the quick charger.
• Check the power connection.
• Check the power cable and mains plug for
damages
• Check the fuse (home).
• Check the quick charger for damages.
Should the quick charger be damaged, stop
using it. Contact the Eurospin customer
service.
• Check the battery terminals for dirt.
Remove any dirt.
• The battery might be defective and have to
be replaced. Only use batteries of the same
type.
The device does not start:
• The battery power might be too low.
Recharge the battery.
• Check whether the battery is correctly
connected to the device.
Slide the battery onto the device in a way that
the battery terminals engage. The battery must
lock in place in the device.
• Check the battery terminals for dirt.
Remove any dirt.
• Check the position of the switch for
clockwise/counter-clockwise rotation. The
switch must be pressed in all the way. If
the switch for clockwise/counter-clockwise
rotation is in centre position (lock), the on/
off switch is blocked.
Info
Wait for at least 10 minutes before switching
the device back on.