28
ENEN
VACUMM CLEANER ASSEMBLy
Warning:
Before fitting or removing attachments, always make sure that the vacuum cleaner has been un-
plugged from the power mains.
•
Insert the suction device (M) into the suction device coupling (G) and press until it clicks into
place.
•
To remove it, it is necessary to press the two release buttons (R) at the same time and to pull it
out (Fig. 2).
•
Insert the telescopic tube (P) into the handle (Fig. 3).
•
Push the slider device (O) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). To shorten the tube, push it back in the opposite direction.
•
Fit the required attachment to the telescopic tube.
USING ThE APPLIANCE
Warning:
Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid any
possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord completely and plug the appliance
into the mains socket.
To switch on, press the foot switch (F) on the appliance. The cleaner is equipped with wheels to
move it easily during use.
IMPORTANT
: The appliance might make a whistling sound that will stop after a few seconds.
Warning:
Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube become
blocked. Remove the cause of the blockage before switching the vacuum cleaner on again.
2
4
3
