11
10
tV connection Using Video cable and "Video input" Jack
(Refer to Figure 1)
1. Remove the Flipper and the Control Unit from the package.
2. Remove the Video Cable from the package. (This is the thin cable that
is not attached to any other component and has the same plug at both
ends.) Plug one end of the Video Cable into the Control Box Jack
labeled "VIDEO."
3. Plug the other end of the Video Cable into the yellow "VIDEO INPUT"
jack of your TV. This jack could be located on either the front, back or
side of your TV.
4. Remove the Power Supply from the package. Plug one end of the
Power Supply into the black Control Box Jack labeled "POWER." Be
sure the plug is fully inserted into the Control Box. Then plug in the
other end of the Power Supply into an AC wall outlet.
5. Turn the power on. The ON and OFF switch is on the side of the black
control box. Turn the television ON.
You can switch between using Flipper and your TV with the TV remote
control by changing between "Video" and "TV" mode.
If you have a TV with a built in VCR, you can switch between using
Flipper and your TV by pushing the “Input” button on your remote.
6. Now you can go to the
Using Flipper
section on page 12 to begin
using your Flipper.
FlippeR inStallation
F
lipper
i
nStallation
F
lipper
i
nStallation
