5 Vanity top
(a) Unpack the top and check for any damage
that might have occured in transit. Check and
confirm the fit of your selected tapware.
(b) Apply a continuous bead of silicone (not
supplied) to the top edge of the cabinet sides
and back. Ensure there are no gaps in the
sealant bead. This will ensure the top stays
securely fitted to the cabinet and no water
spillage will find its way into the cabinet.
No silicone on
front edge
(a) To re-install the drawer, extend the runners.
Place the drawer onto the runners and slide it
back so that the runner hooks insert into the
rear of the drawer.
(b) Make sure the locator pins line up with the
holes in the bottom of the drawer and press
the drawer down so that the pins slot into
place.
7 Drawer re-installation
(a) All edges MUST be sealed with an approved
Silicone Sealant.
8 Sealing
INSTALLATION COMPLETE
INSTALLATION INSTRUCTIONS
VALENCIA
TM
Single Drawer Vanity
6 Waste and tapware
(c) Place the vanity top onto the cabinet ensuring
that the back is flush against the wall and
there is an even overhang on either side of the
cabinet.
(d) Wipe off any excess sealant.
(a) Fit the waste and tapware. Connect the water
supply to the taps and waste pipe to the waste
outlet.
(b) Run hot and cold water and check for leaks.
When satisfied with the results move on to the
next section.
ENGLEFIELD
5
=
=
Locator pin
Runner hook
(c) For 77296A-*: Re-install the cabinet door.
Hook the hinges onto the base plates and press
down as shown.
Hook
