INSTALLATION INSTRUCTIONS
VALENCIA
TM
Single Drawer Vanity
3 Water supply and waste pipe holes
4 Fixing the vanity to the wall
(c) Having drilled the required holes fit the cabinet
into position over the pipework.
(e) Fix the cabinet to the wall using at least
6 screws for the 750mm & 900mm cabinets
and 8 screws for the 1200 cabinets (min 10g
x 75mm) and
*
20mm washers. Screw through
the back wall so that they screw into the nog
and stud(s) in the wall behind.
*
Washers must be used to spread the load.
NOTE:
Before fastening the cabinet make sure
that it is sitting level and square.
NOTE:
Screws should be positioned evenly
and fixed into nogs or studs.
NOTE:
This section is only applicable if you have
purchased alternate trim for your vanity cabinet.
(c) Fix the new trim in place using the screws
that were removed from the original trim.
(b) Unscrew the 3-4 screws from underneath the
trim and remove the trim from the cabinet.
NOTE:
Keep the screws for use later on.
(a) After the drawer has been removed (refer to
section 1), unscrew the trim fixing screws from
each angle bracket located behind either side of
the trim.
2 Changing drawer trims (Optional)
Trim
Angle
brackets
Angle
brackets
(b) With a suitably sized hole saw, drill the holes
for the water supply and waste.
ENGLEFIELD
4
50mm
Maximum
height
260mm
(a) Measure and mark the centres for water
supply and waste pipes on the back of the
cabinet.
NOTE:
Ensure that plumbing holes are positioned
to allow for a maximum height of 260mm between
the bottom of the basin to the base of the trap.
