6
11
4
1
3
8
1
10
5
3
8
9
2
12
W
all fixing holes distance: max. 620 mm
7
9
13
CLEANING INSTRUCTIONS
INSTALLATION CHECKOUT
How to Install the Slide Rail and Soap Dish
INSTALLATION
1397399-AN2-A 06/07/2019
Page 2
ENGLEFIELD
1397399-AN2-A 06/07/2019
Page 3
ENGLEFIELD
STUDIO II SLIDE SHOWER
INSTALLATION INSTRUCTIONS
How to Install the Elbow and Hand Shower
STUDIO II SLIDE SHOWER
INSTALLATION INSTRUCTIONS
1). Determine a suitable position on the finished wall for the slide rail, avoiding cables and pipes
concealed in the wall.
Note:
The slide rail must be fixed to timber studs or nogs in the wall.
2). Mark the position of top & bottom wall fixing holes on the finished wall (Max. 620 mm apart).
3). Fix top & bottom brackets (2) & (4) to the finished wall with the anchors (1) and screws (3).
Note:
Ensure the hole in the top bracket for bracket cover (5) faces up and the hole in the bottom
bracket for bracket cover (6) faces down.
4). Move the hand shower holder (7) to the centre of the rail.
5). Slide the bracket covers (5) & (6) to the rail and adjust the position of them at each end by loosen-
ing the screws (8) inside the bracket covers.
Note:
Ensure the distance between them (Max. 620mm apart) is same as one between the
two wall fixing holes.
6). Mount the rail onto the brackets (2) & (4) and fix both covers in place by using cover screws (9).
7). Insert the endcap (10) into the top of the slide rail.
8). Insert the soap dish (12) with plastic insert (11) into the bottom end of the slide rail and fix in place
using screw (13).
Note:
Be careful not to overtighten.
Note:
To perform installation the installer must provide a
G1/2”B water supply nipple (14). The distance
from the end of the nipple to the finished wall
surface should be between 10mm and 15 mm
and be perpendicular to the finished wall.
1). Apply thread tape or sealant to the water supply
nipple.
2). Fit the O-ring (15) into groove in the base of elbow
(16) and then screw it onto the water supply nipple
clockwise until the back surface of the elbow touches
the wall.
Note:
Ensure the outlet of the elbow faces down.
3). Insert the rubber filter washers (17) in both ends of
shower hose (18). Connect and hand tighten the
shower hose to the hand shower(19) and the elbow
(16). Make sure hose goes through the soapdish
(12).
4). Attach hand shower onto the hand shower holder(7).
1). Ensure that all connections are tight.
2). Turn on the main water supply and check for leaks. Repair as needed.
3). Disconnect the hand shower from the shower hose and then turn on the shower mixer for mini-
num one minute to flush any residual debris from the line.
4). Check and clean filter washers as necessary. Reinstall the shower hose back to the hand shower
and the elbow.
5). Adjust the height of hand shower by twisting the bracket lever & sliding it up or down.
Clean all finishes with mild soap and warm water. Wipe entire surface completely dry with a clean
soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemials etc,
which could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Englefield fittings.
10~15mm
Max
ø 32mm
14
16
15
17
18
12
17
19
