Engl Screamer 50 II Combo E330II, Руководство оператора

Страница: 7 / 16

Footswitch Master A/B, Reverb (conventional 6.3mm (¼“) TRS)
Use this jack to connect a conventional footswitch with two switching functions, for example, the ENGL Z4
(2 x off/on – Single Pole Single Throw or SPST for short).
Tip:
switching between Master A and Master B.
Sleeve: switching the Reverb on and off.
Footswitch Clean/Lead, Gain Lo/Hi (conventional 6.3mm (¼“) TRS)
Use this jack to connect a conventional footswitch with two switching functions, for example, the ENGL Z4
(2 x off/on – Single Pole Single Throw or SPST for short).
Tip:
switching between Clean and Lead channels
Sleeve: switching between Clean and Crunch (in the Clean channel)
switching from Soft Lead to Heavy Lead (in the Lead channel)
Mid Boost Plusflex
The sound function „Mid Boost Plusflex“ is newly designed for the Screamer 50 Mark II Amp. It can be
activated via a selector switch located on the back panel of the amplifier. With this function, you can create
your own individual sound, and thus expand the entire sound spectrum. It can be paired with either Gain
Lo/Hi or Master A/B.
There are four options to enable or automatically assign the Mid Boost feature:
1. Mid Boost off
for all settings of the amp (channels, gain levels, master)
- the Mid Boost sound function is generally disabled (off)
2. Mid Boost Plusflex Hi Gain
- Mid Boost is automatically activated on „Gain Hi“
3. Mid Boost Plusflex Master B
- Mid Boost is automatically activated on „Master B“
4. Mid Boost on
for all settings (channels, gain levels, master) of the amp
- the Mid Boost sound function is generally activated (on)
Noise Gate Threshold Level
This control activates the onboard Noise Gate serving to suppress any excess noise generated when the
Lead Channel or Lead Channel and Gain Hi are active. To this end, twist the knob clockwise, near or just
beyond the 9 or 10 o‘clock position. In addition the Noise Gate can be controlled remotely (on/off) via a
footswitch connected to the responsible footswitch jack or via the ENGL Z9 connected to the S.A.C. port. If
you want to control the Noise Gate remotely via footswitch, you must set the Threshold knob to 10 o‘clock
or beyond. Use this knob to set a threshold value (that is, the noise level) at which the Noise Gate activates