5
16 DEPTH BOOST (Lo/Hi)
Bass boost feature for the Rhythm channel in the power amp
17 PRESENCE LEAD
Treble control for the Lead channel in the power amp
18 DEPTH BOOST (Lo/Hi)
Bass boost feature for the Lead channel in the power amp
19 POWER
AC power on/off
REAR PANEL
20 AC SOCKET
Connect AC cord here
ATTENTION:
Ensure you use an intact AC cord with an insulated plug only!
Before you power the amp up, ensure the voltage value printed beside the
AC socket corresponds to the available current.
21 AC FUSE BOX
Contains mains fuse (rear chamber) and spare fuse (front chamber)
NOTE:
Ensure replacement fuses bear identical ratings (refer to the table)!
22 FOOTSWITCH: RHYTHM/LEAD; VOLUME LEVEL SWITCHING ............................
TIP 6
1/4" stereo jack for double footswitches, executes the following functions:
1.Channel switching RHYTHM/LEAD (mono terminal)
2.Switching between the two Master volume levels Hi and Lo (stereo terminal)
23 F.X. LOOP SEND
Signal output for the Effects loop. Connect this output to a signal processor’s
input/return jack via a shielded cable with 1/4" plugs.
24 F.X.LOOP RETURN
Signal input for the Effects loop. Connect this input to a signal processor’s
output/send jack via a shielded cable with 1/4" plugs.
25 BALANCE
FX mix control for the Effects loop: Rotate the knob to the DRY position for the pure amp signal,
i.e. no effect on the signal. Turn clockwise to blend in an effect connected to the loop to the dry
signal (parallel/passive). At the EFFECT position, only the wet signal, i.e. the signal sent from
the FX device is fed to the power amp (serial/passive).
NOTE:
If no effects processor is connected to this loop, leave this control
in position DRY!
26 POWER TUBE FUSE
Power tube fuse (E.C.S.) for the left power tube (as seen from the rear of the chassis);
LED illuminates when a fuse is defective.
27 POWER TUBE FUSE
Power tube fuse (E.C.S.) for the right power tube; LED illuminates when a fuse is defective.
