Engl E610II, Руководство оператора

Страница: 15 / 24

FX Loop I Send
Connect this FX Loop I output to a signal processor´s input/return or an effect pedals´s input/return jack
using the shortest possible shielded cord equipped with 6.3 mm (¼“) plugs. Activate and deactivate it via
the FX Loop I / II button, which switches between these two loops. In the signal path, FX Loop I is located
post preamp and pre the two power amp Master knobs.
FX Loop I Return
Connect this FX Loop I input to a signal processor´s output/send jack or an effect pedal´s output/send jack
using the shortest possible shielded cord equipped with 6.3 mm (¼“) plugs. Activate and deactivate it via
the FX Loop I / II button, which switches between these two loops. In the signal path, is located post preamp
and pre the two power amp Master knobs.
FX Loop I Balance
FX mix control for FX Loop I. When the knob is set to Dry, the amp signal is routed through with no processed
signal (0% wet balance) added to the mix. Twist the knob clockwise to blend in the processed signal (paral-
lel/passive, wet balance 1-99%, depending on knob position). When the knob arrives at the Effect position,
only the wet signal (that is, the processed signal generated by the connected effect device) is patched to
the power amp (serial, 100% wet).
NOTE: Set this knob to Dry when the FX Loop is not in use! Settings between 9 and 3 o‘clock position reduce
the signal level. In the event of contact corrosion of the FX Return socket, volume fluctuations may occur.
FX Loop II Send
Connect this FX Loop II output to a signal processor´s input/return or an effect pedals´s input/return jack
using the shortest possible shielded cord equipped with 6.3 mm (¼“) plugs. Activate and deactivate it via
the FX Loop I / II button, which switches between these two loops. In the signal path, FX Loop II is located
post preamp and pre the two power amp Master knobs.
FX Loop II Return
Connect this FX Loop II input to a signal processor´s output/send jack or an effect pedal´s output/send
jack using the shortest possible shielded cord equipped with 6.3 mm (¼“) plugs. Activate and deactivate
it via the FX Loop I / II button, which switches between these two loops. In the signal path, is located post
preamp and pre the two power amp Master knobs.