Learn more about EnGenius Solutions at
www.engeniustech.com.sg
Datasheet
ENH500
ECB7510Datasheet Version 18022009
BUSINESS CLASS
ENH500
ENH500 Data sheet Version 150711
*Theoretical wireless signal rate based on IEEE standard of 802.11 b, g, n chipset used. Actual throughput may vary. Network conditions and environmental
factors lower actual throughput rate.
** All specifications are subject to change without notice
FEATURES
SPECIFICATIONS
High output power
Transmit high output power programmable for different country selections
High Data Rate
High speed transmitting rate up to 300Mbps with 2T2R 802.11n
Long range transmitting
Transmit power control and distance control (ACK timeout)
Signal Strength Display
RF signal strength status indicates in LEDs of 3 colors, makes network build-up easier. LED indicators
have the best transmit and receive signal for traffic communication
Multiple SSID
4 SSID supported. Each SSID can set itself wireless or WAN access setting
NETWORKING
PPPoE
Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when failed
or disconnected
PPTP
Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
802.11i & 802.1x
WPA, WPA2 & IEEE802.1x Authenticator
MANAGEMENT
Firmware Upgrade
Upgrading firmware via web browser, setting are reserved after upgrade
Reset & Backup
Reset to factory default. User can export all setting into a file via WEB
Ping & Trace Route
Built-in PING function & Trace Route function in Web GUI
MIB
MIB I, MIB II(RFC1213), Private MIB
SNMP
V1, V2c
SPECIFICATIONS
MCU
Atheros AR7240
RF
Atheros AR9280
Memory
32MB
Flash
8MB
Standard
IEEE 802.11 a/n
Physical Interface
- 1 x LAN Port with PoE support
- 1 x LAN Port
- 1 x Reset
Data rate
300 Mbps
LEDs status
- Power Status
- LAN1/LAN2 (10/100Mbps)
- WLAN (Wireless is up)
- 3 x Link Quality (Client Bridge mode)
Security
- WEP Encryption-64/128/152 bit
- WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
- WPA/WPA2 Enterprise (WPA-EAP using TKIP)
- 802.1x Authenticator
- Hide SSID in beacons
