ENFORCER SK-1323-SDQ, Руководство пользователя

Страница: 14 / 15

ENFORCER Outdoor Stand-Alone Keypads
SECO-LARM U.S.A., Inc 15
Troubleshooting
The keypad will not accept
user codes or user cards. 
Make sure the Output #1 Access Mode is programmed to accept
user codes.
(See page 11,
Setting the Output #1 Access Mode .)

If an incorrect card or code has been entered, the keypad may
be in Wrong Code Lockout. Wait 1 minute.
(See page 15,
Wrong Code Lockout .)
Output #2 will not activate.

Make sure that Output #2 is programmed for the correct function.
(See page 13,
Programming the Output #2 Function ).
Egress input is not working.

Check that the egress device is wired correctly.
(See page 4,
Wiring Diagram ).
Relay output will not stop.

Make sure that the output is not set for toggle mode.
(See page 13,
Programming the Output #1 Timer and
Programming the Output #2 Timer ).
The keypad will not program new
user codes or user cards. 
Before inputting new code or card, check the left LED. If it is red,
previous user data exists. Press to delete.
The keypad will not program a
new Master Card. 
Before inputting new code or card, check the left LED. If it is
solid green, a Master Card is already programmed. Press
to delete.
Programming option will
not work.

It is likely the keypad is not in the correct mode. Press until
the right LED turns green to put the keypad in Standby Mode.
Enter Programming Mode and begin again.
Using the Keypad
Entering a User Code

To activate either Output #1 or Output #2 with a user card, hold the user card in front of the keypad.
The keypad will beep once the user card has been read.
Using a User Card
Wrong Code Lockout
For programming instructions, see page 10, Programming Instructions .

To activate either Output #1 or Output #2, enter the user code directly into the keypad.

Do not enter the user ID number. The user ID number is only used during Programming Mode.
Example: If a user code for Output #1 is 4321 , enter to trigger Output #1.

If a wrong code is entered or a wrong card is swiped 5 consecutive times, the keypad will go into lockout
for 1 minute. During this time, no codes can be entered and no cards can be swiped.

Pushing buttons or swiping cards during lockout will extend the lockout time.
Using a User Card with a User Code

If Output #1 is programmed to accept a user card with a user code, swipe the user card. Immediately
enter the user code. This may be done in reverse order.
4 3 2 1