ENFORCER Surface-Mount Wave-to-Open Sensor with Manual Override Button
SECO-LARM
U.S.A., Inc
3
Mounting and Wiring Diagram:
Installation:
1.
Drill holes as shown above and mount the enclosure base. For weatherproof installation, install to a
flat surface so the rubber sealing pad has a good seal. Otherwise apply silicone sealant (not
included) around the back of the base before installing. Thread the wires through the wiring hole.
2.
Connect the wires from to the Request-to-Exit Sensor according the
Wiring Diagram
above.
3.
Slide the sensor plate and plastic mounting rails into the enclosure base and use the two screws to
attach the manual override assembly taking care not to crimp the wires (see Overview, pg. 2).
4.
Tamp the screw plugs into the holes. Remove clear protective film from the sensor before use.
WARNING:
Do not connect any device that will exceed 1A@24VDC.
Changing the LED Color Jumper Placement:
Adjusting the sensor range and trigger time:
1.
The sensor range can be adjusted from 1
9
/
16
"~6" (4~15 cm).
2.
The trigger time can be adjusted from 0.5~30 seconds or toggle.*
NOTE:
Do not force the adjustment trimpots to turn. Only minimal
force is needed.
Standby: Green
Trigger: Red
Standby: Red
Trigger: Green
(default)
COM
Use disassembled enclosure
base as a template to mark the
locations of the 4 mounting holes
and wiring hole for drilling.
Red Wire: +12~24VDC
Brown Wire: Ground (-)
Blue Wire: COM
Purple Wire: N.O.
Green Wire: N.C.
NC
NO
Manual override
assembly
Relay (N.O.)
Relay (COM)
Relay (N.C.)
– GND
+ 12~24VDC
5-Pin Terminal
Sensor
plate
Green
wire
Blue
wire
Trigger time
adjustment
Sensor range
adjustment
Sensor Back
Screw plugs
Housing assembly
screws
Screw Plugs:
Trigger time: 0.5~30 seconds, toggle*
Default: 0.5 seconds
*Set trigger time to maximum for toggle
0.5s
30s
Sensor range: 1
9
/
16
"~6" (4~15 cm)
Default: 6" (15cm)
15cm
4cm
