ENFORCER Passive VGA Balun
SECO-LARM U.S.A., Inc.
1.
For LCD monitors under 17” or CRT monitors, use
sync mode 2. If there is no image, switch to sync
mode 1.
2.
For LCD monitors over 17”, use sync mode 1. If
there is no image, switch sync mode 2.
3.
If there is still no image, see
Sync Balancing DIP
Switch
.
VGA Cable
Installation:
Sample Application:
Overview:
1.
Determine the location where the VGA over Cat5e/6 units will be placed as well as how much Cat5e/6 cable will be
necessary.
2.
Connect the VGA source to the transmitter’s “VGA Source” connector using a VGA cable.
3.
Connect the VGA display or other destination device into the receiver’s “VGA Monitor” connector using a VGA cable.
4.
Connect the receiver and transmitter units using a Cat5e/6 cable.
5.
If using Cat5e/6 shielded twisted pair (STP), ground the cable’s shield to the ground screw on both units.
6.
Adjust the sync mode switch (see below).
7.
Adjust the system balancing DIP switch (see below).
Cat5e/6
Up to 443ft (135m)
1
PC or DVR
Monitor
VGA Cable
Cat5e/6 Shield
2
Ground the cable’s shield to the ground screw
Sync Mode Switch:
Sync Balancing DIP Switch:
1.
For CRT monitors, if no image appears, it may be
necessary to adjust the sync balance.
2.
If there is no image, turn on switch #1. Flip each
switch one at a time until an image appears.
3.
If each DIP switch setting has been tested but no
image appears, it may be necessary to use shielded
twisted pair (STP).
1
Check specifications on page 2 for range at each resolution.
2
Unit works with unshielded twisted pair (UTP) and shielded twisted pair (STP). For best results in areas with high interference, use STP.
Transmitter:
Receiver:
Ground screw
Cat5e/6
VGA Input
Sync mode switch
Cat5e/6
Ground screw
3
Sync balancing
DIP switch
VGA Output
