ENFORCER Enhanced Extenders for HDMI
®
over Single Cat5e/6
4
SECO-LARM U.S.A., Inc.
HDMI device does not function
correctly
Use T568-B wiring standard
Make sure the extender is powered on both sides.
Make sure the source and the display are powered.
Test the Cat5e/6 cable between the receiver and transmitter and make sure
it is functional.
Make sure that there are no problems with the HDMI source, HDMI cables,
or HDMI display by plugging the source directly into the display using an
HDMI cable
Make sure that the transmitter and receiver are plugged into the correct units
Make sure the HDMI source is compatible with the HDMI display.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a period of one (1) year from the
date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,
transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal
usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects
in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM option. In no event shall
SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is one of continual
development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for
misprints or typographical errors.
Copyright © 2013 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission
of SECO-LARM.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLCC in the United States and other
countries.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
PICHN1
Tel: (949) 261-2999 | (800) 662-0800
Email: [email protected]
MiMVE-AT11-x1NQ_1404.docx
Sample Application:
Troubleshooting:
Transmitter
Receiver
HDMI Source
IR Rx
IR Tx
H
D
M
I
C
ab
le
Remote
control
Display
Transmitter
Receiver
HDMI Source
IR Rx
IR Tx
Remote control
Display
Standard installation of MVE-AT11-01NQ
Installing MVE-AT11-01NQ transmitter with MVE-AT11-W1NQ receiver
Cable Legend:
HDMI
Cat5e/6
Power
IR
Up to 230ft
(70m)
Up to 230ft
(70m)
