3
E-932-S16RRQ
Installation and Alignment
LED functions:
Red (on): Power
Yellow (off): Aligned
Yellow (on): Out of Alignment
Yellow (on) after being aligned: Unit Triggered
Installation:
1. Decide where to mount:
a. The reflector should be directly across from
the transmitter/receiver.
b. The unit should not interfere with normal
movement around the protected area.
2. Wire the unit - Run the wires to the back box
where the sensor is to be mounted. Keep
wires hidden where possible, and expose them
only at the very end where needed to connect
to the transmitter/receiver. (see fig.4)
3. Mount the transmitter/receiver (flush mount)
(fig. 3) - Mount flush to the wall with two
mounting screws.
4. Initial test - Temporarily hold the reflector to the
wall and power up the unit to test alignment
before permanent mounting. (See Power and
Alignment below.)
Power and Alignment:
1. Power up the transmitter/receiver. The red LED
will turn ON to indicate power is present. The
yellow LED on the unit will turn OFF to indicate
they are aligned properly.
2. Alignment - If the unit is connected to power,
and the yellow LED does not turn off while the
red LED is on, the unit and reflector are not
aligned. Adjust the unit on its pivot points until
the yellow LED turns off, indicating alignment.
(Fig. 1.)
Testing:
1. Do a walk-through test. Walk between the
transmitter/receiver and the reflector. This
should break the beam, turn the yellow LED
on, and trigger the alarm panel or warning
device.
2. Replace the lens covers on the transmitter/
receiver. Test again one last time.
E-932-D33TBQ
Installation and Alignment
LED functions:
TX RED (on): Power
RX RED (off): Aligned
RX RED (on): Out of Alignment
RX RED (on) after being aligned: Unit Triggered
Installation:
1. Decide where to mount:
a. The transmitter and receiver should be
facing each other.
b. The units should not interfere with normal
movement around the protected area.
2. Wire the units - Run the wires to the back
boxes where the sensors are to be mounted.
Keep wires hidden where possible, and
expose them only at the very end where
needed to connect to the transmitter and
receiver. (see fig.4)
3. Mount the transmitter and receiver (flush
mount) (fig. 3) - Mount flush to the wall with two
mounting screws each.
4. Initial test - Power up the units to test alignment
before permanent mounting. (See Power and
Alignment below.)
Power and Alignment:
1. Power up the transmitter and receiver. The red
LED on the transmitter should turn ON to
indicate power is present. The red LED on the
receiver should turn OFF to indicate the two
are aligned properly.
2. Alignment - If the receiver is connected to
power, and if the red LED does not turn off
while the receiver is on, the transmitter and
receiver are not aligned. Adjust the units on
their pivot points until the red LED on the
receiver turns off, indicating alignment. (Fig. 1.)
Testing:
1. Do a walk-through test. Walk between the
transmitter and receiver. This should break the
beam, turn the red LED on, and trigger the
alarm panel or warning device.
2. Replace the lens covers on the transmitter and
receiver. Test again one last time.
