ENFORCER 50ft Reflective Photoelectric Beam Sensor
4
SECO-LARM U.S.A., Inc.
WARRANTY
: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service
for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the
repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair,
or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such
equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal
or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in
part, without the written permission of SECO-LARM.
MI_E-931-S50RRGQ_160216.docx
PITSW3
SECO-LARM
®
U.S.A., Inc
.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
E-mail: [email protected]
Troubleshooting:
Sensor does not detect the object.
Change the angle of the sensor or readjust
the sensitivity setting.
The beam sensor LED will not turn green.
Clean the sensor and reflector with a damp
(not wet) cloth.
Adjust the reflector and/or sensor for proper
alignment.
Beam sensor LED lights when object
is detected, but there is no output.
Check wiring between the sensor and local
alarm device.
Sample Applications:
Garage
Door
Gate
Vehicle
Detection
Assembly
Line
Other Sensors Available:
Dual and
Quad Beam
Curtain and
Barrier
Optional Accessory:
Reflector Hood
E-931ACC-HR1Q
Provides extra
protection for the
reflector.
Compatible with Reflective Photoelectric Beam Sensor models
E-931-S50RRGQ, E-931-S35RRQ, and E-931-S33PRGQ.
Reflective
Photobeam
