Enerzone DESTINATION 1.9, Руководство пользователя

Страница: 10 / 38

Page 10 Product Specification Manual - Destination 1.9
ENGLISH
1.4 EPA Loading
The loading methods shown below are those that were used during emissions certification.
1.4.1 Air control
The air control is located above the door. To open the
air control, insert the removable handle onto the air
control and push the air control handle completely
to the right (High). This will increase the burn rate.
To close the air control, push the air control handle
completely to the left (Low). This will decrease the
burn rate.
Do not leave the handle on the air
control after use, as it will get very hot.
1.4.2 High burn rate (primary air control open)
Open the air control completely. Criss cross 6 kindling wood pieces in the back of the firebox.
Then, place six small pieces (2”x2”) of wood on the kindling crossing them at the greatest
possible angle. Criss cross ten others kindling wood pieces on the small pieces of wood. Tie
knot with five sheets of paper and place them on top of the kindling wood. Light up the paper
and let the door completely open for two minutes. Close the door.
When the kindling and the small pieces of wood are almost completely burnt out and it is
possible to break them into pieces, level the coal bed and put four logs in the firebox in an east-
west orientation. Place a medium log (about 4”x4”) in front of the combustion chamber and the
biggest log (about 5”x5”) in the back of the combustion chamber. Place the last two medium
pieces on top of the two others in an orientation that points to the right. Do not leave space
between the pieces. Let the door open ajar at 90° for 5 minutes and close the door.
1.4.3 Medium and low burn rate
On a 2” coal bed that is still red, place five logs of approximatively 4”x4” or 3”x3” with an east-
west orientation. Place two logs on the coal bed with approximatively 4” between them and the
other three on top. There should be air space between each logs and between the logs and the
bricks. Let the door ajar at 90° for 5 minutes and then close the door with the primary air control
fully open. Leave to burn with the primary air control open for approximately 10 minutes and
then close the primary air control completely for the low burn rate and halfway for the medium
burn rate.
A
WARNING
Before opening the door completely to add
wood to the insert, the fan must be turned OFF
to avoid blowing ash outside the combustion
chamber. Refer to section "5.1 Blower" of the
owner's manual for how to turn OFF the fan.