1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06
Seite 3 von 6
Notices
•
Installation and assembly of electrical equipment must be performed by qualified electri-
cians.
•
When connecting KNX/EIB interfaces skills are provided by KNX™-Training.
•
Ignoring the instructions may damage the device as well as causing fire or other ha-
zards.
•
This manual is part of the product and must remain with the end user.
•
The manufacturer is not liable for any costs or damages incurred by the user or third
parties through the use of this device, misuse or malfunction of the connection, malfunc-
tion of the device or the subscriber equipment.
•
Opening the case or other authorized changes or modifications will void the warranty!
•
The manufacturer is not liable for improper use.
Assembly and connection
Requirements:
•
One of the following power supplies
- 20 bis 30 V DC
- 16 bis 24 V AC
- „Power over Ethernet“ (IEEE 802.3af), Class 1
- AUX-Output of the Enertex
®
KNX PowerSupply 960 if there is no additional KNX choke
connected to it
•
10/100 Mbit compatible Ethernet connection
•
KNX/EIB bus connection
Commissioning
Boottime is about 2 seconds.
The default network setting ist DHCP.
The default KNX physical address is 15.15.1.
The green LED signalizes LAN activity, the yellow LED signalizes KNX bus activity. If the the red
LED is active, device is in programming mode.
Enertex
®
Bayern GmbH – Ebermannstädter Straße 8 - 91301 Forchheim - Deutschland - [email protected]
