OutBack Power
| Commissioning Document
©2019 OutBack | an EnerSys company
FA
-KF-10/
11
/2019
Page 6 of 12
1. Using the table below, record the IP address and the DNS address for the LAN side of the
gateway router. Determine two unused static IP addresses used for each of the units in the
stack. To learn how to do this, search “determining available static IP addresses” on the
desired search engine.
Table 2 – Local network settings
Information Title
Site Info
Notes
Gateway LAN Address
Primary DNS Address
Secondary DNS Address
Only use if known, otherwise
leave blank.
Available Static IP Address 1
For master SkyBox
Available Static IP Address 2
For slave SkyBox
Subnet Mask
255.255.255.0
Use for both units
Next, on the master unit, arrow down once and make the following changes:
2. Change the
IP address
to the value identified in the previous step for the master SkyBox.
3. Enter the
Subnet mask, 255.255.255.0
.
4. Enter the
Gateway LAN address
.
5. Arrow down once more.
6. Enter the
Primary DNS
.
7. Tap
Apply
to save changes.
8. Repeat steps 3-7 on the slave unit, ensuring the IP address identified for the slave SkyBox
is used.
NOTE:
The screens shown below are for reference only. The values will vary from site to site.
Figure 7 – IP Address and DNS Menus
