Page 23
FCC
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device when
powered by a DC source, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
o
Reorient or relocate the receiving antenna.
o
Increase the separation between the equipment and the receiver.
o
Consult the dealer or an experienced radio/TV technician for help.
M
AT
E
R
T
S
PV
+
PV
–
BAT
–
BAT
+
MATE
Port
(RJ45)
RTS
Port
(RJ11)
In 23.2 V 0.0 A
Out 27.6 V 0.0 A
0.000 kW 0.0 kWH
AUX: OFF Sleeping
Ethernet
Port
1
st
MATE
1
2
3
4
5
6
7
8
9
10
MATE3s
Inverter
Additional (Stacked) Inverters
HUB10.3
Communications Manager
The MATE3s connects to other OutBack products using
the HUB port. To learn what configurations are available,
see the appropriate manual. To make MATE3s settings
for a configuration, see the
MATE3s Programming Guide
.
FLEXmax
Charge
Controller
(FM80)
M
AT
E
R
T
S
MATE3s
Inverter
PV
+
PV
–
BAT
–
BAT
+
MATE
Port
(RJ45)
RTS
Port
(RJ11)
MATE3s
FLEXmax
Charge Controller
(FM80)
Product
Configurations
(examples)
Communications Interfacing
(examples)
Wireless Router
Wireless
Access Point
Wired
Cellular
Modem
HUB
Port
The MATE3s interfaces with other devices using a wired connection to the
Ethernet port. The connections here are used for Internet access with the
OPTICS RE interface. Other connections are possible. The MATE3s can
connect using a network switch or a wireless network router.
NOTE
:
All communications use
CAT5 (non-crossover) cable.
Page 2
Communications
900-0124-
01-
02 Rev B
©2017 OutBack Power. All Rights Reserved.
LED Indicators
