background image

AMER-EN-TM-ODY July 2021

www.odysseybattery.com

realistic. Because the discharge is for such a short time, it is more like a pulse. The low impedance 
of ODYSSEY battery technology allows them to maintain a higher voltage for more starter pulses, 
resulting in less heating of starter motors and cables. Higher power output results in a faster start.

  

What is impedance?

        The impedance of a battery is a measure of its internal resistance. The lower the battery impedance 

the more the available power. The impedance of ODYSSEY

®

 AGM

2

 batteries is considerably  

lower than that of a conventional automotive or marine battery. The high rate discharge capability  
of ODYSSEY AGM

2

 automotive and marine batteries is significantly higher than that of conventional 

automotive and marine batteries. 

    What is Reserve Capacity (RC) rating?

       The RC of a battery is the number of minutes it can support a 25-ampere load at 80°F (27°C) before 

its voltage drops to 10.50V for a 12V battery. A 12V battery with a reserve capacity rating of 100 will 
deliver 25 amps for 100 minutes at 80°F (27°C) before its voltage drops to 10.5V.

  

What is the short-circuit current of these batteries?

       Typically thousands of amps. As mentioned before, the AGM

2

 batteries have a very low internal 

resistance, which means that the short circuit current is very high. Precautions should be taken to 
avoid short circuits as equipment and battery damage will occur.

  

What is the operating temperature range of these batteries?

       The operating range varies based on the battery type. Refer to table 3 on page 7 for details.
  

Is the battery ruined if it is dropped?

       It is possible to damage the internal connections as well as the external container, leading to a  

damaged the battery. Batteries with visible external damage should not be used.  Dropped batteries 
should be tested prior to use.

VIII. DEFINITIONS OF ACRONYMS

  

AGM

 – Absorbed Glass Matt battery. This is a type of VRLA battery in which all the electrolyte in the 

battery is absorbed into the glass mat separator material.

 

 TPPL – Thin Plate Pure Lead.

 This refers to the fact that these batteries are made of very thin plates, 

which do not contain any calcium or other typical impurities which deplete battery voltage over time. 

  

VRLA Battery – Valve Regulated Lead Acid Battery.

 These lead acid batteries are designed to include 

pressure relief valves that allow for nearly 100% recombination of the gasses that would vent in 
traditional flooded batteries. Because of this very efficient recombination process, there is no need  
to periodically add water to these batteries.

    

OCV – Open Circuit Voltage.

 This is a voltage reading obtained from a battery that is not charging or 

discharging. To get an accurate OCV on AGM

2

 batteries, it is important to wait at least four hours after 

charging or 30 minutes after discharging to take the voltage reading. 

   DOD – Depth of Discharge.

 This is the measure of how many amp hours were taken out of a battery 

compared to the battery’s rating.  For example, a 100 amp-hour battery which has 40 amp-hours  
removed during discharge is said to be at 40% DOD. 

 

 SOC – State of Charge.

 The level of charge of a battery. It can be approximated by evaluating the  

battery’s OCV.

15

Содержание NSB-AGM

















Отзывы: