14
016-564-B0-001, Rev. A1 (05/2022)
2.0 Installing an Alpha® APX3-G Unit, continued
Fig. 2-3, Wall-mounting holes on APX3-G unit
Fig. 2-4, Sealing Plug Locations (Cover Removed)
2.3 Wall Mount Installations
For wall mounting, securely fasten the unit to the wall with four 8mm lag bolts of appropriate grade and material to support
the unit.
Required Tools and Materials:
•
Four customer-supplied stainless steel M8 × 90mm long (or larger) lag bolts
•
Four customer-supplied stainless steel M8 flat washers, 24mm max. diameter × 2mm min. thickness
•
Ratchet w/ 13mm socket
•
Level
•
Stud finder (optional)
•
Drill w/ 5mm drill bit
•
Tape measure
•
Assorted screwdrivers (#2 Phillips head, #2 Standard head)
Procedure:
1.
Unpack the unit.
2.
Remove the four securing screws from the exterior sides of the cover, loosen the two retaining screws and remove the
cover from the chassis.
3.
Place the APX3-G template (located on last page of this manual) at the required height for mounting and mark the
location of the mounting holes.
4.
With the 5mm drill bit, drill the four holes for mounting.
5.
Screw the four lag bolts with washers into the mounting surface. Leave approximately 2-3mm between the screw
head and mounting surface.
6.
Remove the sealing plugs in the front of the mounting holes.
The populated cabinet weighs approximately 16kg (35.4 lbs). Installer needs to ensure the wall is
capable of supporting the loaded enclosure. Direct mounting to wall studs and 19mm (3/4") plywood
backing is required.
CAUTION!
Before installing an enclosure, the location and method of mounting must be approved by the utility.
ATTENTION:
Sealing
Plugs
Sealing
Plugs
Mounting
Holes
Sealing
Plugs (×4)
